Control Module And Hydraulic Unit

Courtesy of AUDI OF AMERICA, LLC

Rubber Bushing
Mounting Bracket
Bolt
- Tighten in two steps alternating from side to side.
- Step 1: 1 to 1.5 Nm (to position the seal)
- Step 2: 2.5 Nm
ABS Control Module -J104-
- If the ABS Control Module -J104- is faulty, it can be replaced separately.
- If the ABS Hydraulic Unit -N55- is faulty, it must be replaced together with the ABS Control Module -J104-.
- Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING
- Can be replaced separately if faulty.
- Refer to CONTROL MODULE, SEPARATING FROM HYDRAULIC UNIT
- Refer to CONTROL MODULE, INSTALLING ON HYDRAULIC UNIT
Brake Line
- 14 Nm
- To the brake caliper
- Do not change the bending shape.
- Replace a damaged or bent brake line
ABS Hydraulic Unit -N55-
- If the ABS Control Module -J104- is faulty, it can be replaced separately.
- If the ABS Hydraulic Unit -N55- is faulty, it must be replaced together with the ABS Control Module -J104-.
- Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING
- Refer to CONTROL MODULE, SEPARATING FROM HYDRAULIC UNIT
- Refer to CONTROL MODULE, INSTALLING ON HYDRAULIC UNIT
Brake Line
- 16 Nm
- From brake master cylinder to the hydraulic unit
- Do not change the bending shape.
- Replace a damaged or bent brake line
Brake Line
- 14 Nm
- From brake master cylinder to the hydraulic unit
- Do not change the bending shape.
- Replace a damaged or bent brake line
Bolt
- 25 Nm