Peripheral Camera System, Calibrating

-- The vehicle must be on a level surface.

NOTE:

The vehicle in the illustration is only a basic outline.

Courtesy of AUDI OF AMERICA, LLC

-- Roll out the :VAS721001  at the left and right near the vehicle.

-- Install the rear and front clamping strip on the :VAS721001  .

-- Align the crosshairs -2- to the front axle of the vehicle (center front wheel).

-- Align both calibration devices parallel. The vehicle must be located in the center between both calibration devices.

Pay attention to the following measurement requirements:

• Dimension -a- 2000 to 2500 mm ± 5 mm, front and rear the same
• The dimension -b- must be the same on both sides
• The dimension -c- must be the same on both sides

-- Set-up the requirement for the vehicle. Refer to Requirement for the Calibration of the Vehicle .

Calibrating Procedure 

The Vehicle Diagnostic Tester is connected.

-- Perform the calibration. Refer to Vehicle Diagnostic Tester in the "Guided Functions  " mode.