Windshield Projection Head Up Display Control Module, Calibrating, Before Product Improvement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Vehicle Diagnostic Tester
Calibration Board for Head-Up Display: VAS721003

Courtesy of AUDI OF AMERICA, LLC

Conditions

-- The windshield projection control module must be calibrated under the following conditions:

The Windshield Projection Head Up Display Control Module -J898- was replaced.
The windshield was removed and installed.
"No or incorrect basic setting/adaptation" is stored in the DTC memory.

Preliminary Work

-- Move the vehicle onto a secure flat surface.

-- Apply the parking brake - the vehicle must not move during the measurement.

-- Fold down the left and right sun visors, disengage them and move them to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Engage the Calibration Board for Head-Up Display: VAS721003 on the center support -1 and 2- for the sun visor.

Calibrating Procedure

The Vehicle Diagnostic Tester is connected.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

Body
Electrical system
01 - OBD-capable systems
82 - Windshield Projection Head Up Display Control Module - J898
82 - Windshield projection control module, functions
82 - Head up display calibration

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

-- After calibrating the windshield projection control module successfully, end "calibration", turn off the ignition and disconnect the diagnostic connector.