Windshield Projection Head Up Display Control Module, Removing And Installing: Removing

If the Windshield Projection Head Up Display Control Module -J898- is being replaced, then perform the test plan for replacing the control module.

-- Perform the "control module, replacing" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation

-- Press out the cover -2- from the instrument panel -1- using the Wedge Set:T10383 .

Courtesy of AUDI OF AMERICA, LLC

-- Cover the Windshield Projection Head Up Display Control Module -J898- -2- with a soft towel.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the windshield. Refer to appropriate Service Information .

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- Only remove the designated bolts from the control module.

- Never remove the bolts for the housing upper section.

-- Remove the bolts -1-, -3- and -4-.

-- Slightly pry out the control module -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -3- and -4-.

-- Free up the wiring harness -1- -arrow-.

-- Remove the control module.