All Models
Before checking toe-in, vehicle must be in loaded condition (see CASTER & CAMBER ). Check toe-in with front wheels in straight-ahead position. If not within specifications, loosen tie rod clamping bolts. Rotate both tie rod tubes until toe-in is within specifications. Tighten clamping bolts.
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Caster (Degrees) | Camber (Degrees) | Toe-In (Inches) | Toe-Out On Turns (Degrees) | ||
|---|---|---|---|---|---|---|
| Inner | Outer | |||||
| 2002 | ||||||
| Front | 4 ± 1/2 | 1/2 ± 1/2 | 3/64 to 3/32 | ..... | ..... | |
| Rear | ..... | -2 ± 1/2 | 0 to 1/8 | ..... | ..... | |
| 3.0 si | ||||||
| Front | 9 2/3 ± 1/2 | 1/2 ± 1/2 | 0 to 3/32 | ..... | ..... | |
| Rear | ..... | -2 | 0 to 5/64 | ..... | ..... | |
| 530 i | ||||||
| Front | 7 2/3 ± 1/2 | 1/2 ± 1/2 | 3/64 to 3/32 | ..... | ..... | |
| Rear | ..... | -2 ± 1/2 | 0 to 5/64 | ..... | ..... | |