lemon-mirror:
Home >> Buick >> 1988 >> Skyhawk S/E, Automatic >> Repair and Diagnosis >> Engine Performance >> Ignition System - Direct >> Removal & Installation >> Ignition Module

Ignition Module

  1. Disconnect negative battery cable. Unplug connectors at ignition module. Disconnect spark plug wires from coil pack. Remove ignition module from engine block. Remove coils and assembly plate.
NOTE: If spark plug boots adhere to spark plugs, use Boot Remover (J-36011). Twist first and then pull upward. Boots must be in place on housing prior to ignition system assembly installation or damage may result.
· About lemon-mirror