lemon-mirror:
Home >> Buick >> 2005 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Accelerator Controls Cable Bracket Replacement >> Removal Procedure

Removal Procedure

  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) in Engine Mechanical.
    2. Fig 1: Removing/Installing Cruise Control Cable At Bracket
    GM179339Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the cruise control cable (1) from the throttle lever.
  3. Disconnect the cruise control cable (1) from the bracket (2).
    4. Fig 2: Removing/Installing Accelerator Cable
    GM179346Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the accelerator cable (2) from the throttle lever.
  5. Disconnect the accelerator cable (2) from the bracket (1).
    6. Fig 3: Removing/Installing Electrical Wiring Harness At Accelerator Controls Bracket
    GM179374Courtesy of GENERAL MOTORS CORP.
  6. Remove the wiring harness clip (1) from bracket (3) if necessary (VIN K only).
    7. Fig 4: Removing/Installing Accelerator Controls Cable Bracket
    GM12246Courtesy of GENERAL MOTORS CORP.
  7. Remove the two bolts from the bracket.
· About lemon-mirror