Fastener Specifications

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English)
Front Lower Control Arm Front Bolt
First Pass:	115 N.m (85 lb ft)
Second Pass:	Loosen 720 degrees
Third Pass:	80 N.m (59 lb ft)
Final Pass:	90-105 degrees
Front Lower Control Arm Rear Bolt
First Pass:	80 N.m (59 lb ft)
Final Pass:	60-75 degrees

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Front Lower Control Arm Ball Stud Nut (At Knuckle)
First Pass:	42 N.m (31 lb ft)
Second Pass:	Loosen 120 degrees
Third Pass:	35 N.m (26 lb ft)
Final Pass:	30-45 degrees
Front Lower Control Arm Ball Stud Nut	35 N.m (26 lb ft)
Front Stabilizer Shaft Insulator Clamp Nut	22 N.m (16 lb ft)
Front Stabilizer Shaft Link Nut	65 N.m (48 lb ft)
Front Strut Rod Mount Nut	65 N.m (48 lb ft)
Front Suspension Strut Nut	110 N.m (81 lb ft)
Front Suspension Strut Upper Mounting Nut	65 N.m (48 lb ft)