Removal Procedure
CAUTION:
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position.
- Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
- Electronic Traction Control Brake Pressure Modulator Valve Replacement - Remove
- Electronic Brake Control ModuleBolt 1 - Remove
- Electronic Brake Control Module 1 - Remove
NOTE:
Do NOT pry the components apart.