Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Power Transfer Unit Cover Housing Seal |
| Power Transfer Unit Face Seal |
| Power Transfer Unit Half Shaft Retainer Clip |
| Power Transfer Unit Half Shaft Seal |
| Power Transfer Unit Idler Gear Shaft Tube O-ring - Rear |
| Power Transfer Unit Intermediate Drive Shaft to Input Shaft Seal |
| Power Transfer Unit Input Shaft Seal - Front |
| Power Transfer Unit Rear Output Shaft Seal |
| Power Transfer Unit Propeller Shaft Retainer |
| Power Transfer Unit Propeller Shaft Seal |
| Power Transfer Unit Propeller Shaft Seal O-Ring |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Power Transfer Unit Drain Plug | 40 N.m (30 lb ft) |
| Power Transfer Unit Fill Plug | 40 N.m (30 lb ft) |
| Power Transfer Unit Extension Housing Bolt Refer to procedure for tightening sequence and torque values. |
Power Transfer Unit Case Assemble |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Power Transfer Unit Shift Actuator Bolt | 9 N.m (80 lb in) |
| Power Transfer Unit Bracket Bolt | 22 N.m (16 lb ft) |
| Power Transfer Unit Bolt | 100 N.m (74 lb ft) |
| Power Transfer Unit Heat Shield Bolt | 9 N.m (80 lb in) |
| Power Transfer Unit Vent Hose Connector | 20 N.m (15 lb ft) |