Remote Transmitter

NOTE: All transmitters which are to be recognized by Remote Control Door Lock Receiver (RCDLR) must be programmed in a single programming sequence. If system is placed in program mode, all previously programmed transmitters will be erased upon receipt of programming signal from first remote transmitter. Up to 4 transmitters may be programmed. Do not operate or program remote transmitters in vicinity of other vehicles that are in Remote Keyless Entry (RKE) program mode. This prevents programming of remote transmitters to incorrect vehicle.

Order in which remote transmitters are programmed is important. First remote transmitter programmed will be transmitter No. 1, and second remote transmitter programmed will be transmitter No. 2. Number on remote transmitters are for reference only: No. 2 can be programmed as No. 1, or vice versa. Additional unnumbered remote transmitters are also available. Use care to program remote transmitters correctly.

Install a scan tool.
Turn ignition switch to RUN position.
Use scan tool Remote Function Actuation Special Function: program remote transmitters in order to place RCDLR in program mode. Doors will lock and unlock in order to confirm program mode.

NOTE: Scan tool must stay connected until all of remote transmitters are programmed.

Press and hold LOCK and UNLOCK buttons simultaneously on one remote transmitter. After a delay of 15 seconds, doors will lock and unlock in order to confirm programming of that transmitter.
Repeat previous step in order to program up to 4 remote transmitters.
Remove scan tool.
Operate remote transmitter functions in order to verify correct system operation.