lemon-mirror:
Home >> Cadillac >> 2004 >> Seville >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System >> Repair Instructions >> Rear Integration Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing RIM
    GM650999Courtesy of GENERAL MOTORS CORP.
  1. Install the RIM (1) to the electrical component mounting panel.
  2. Push the RIM (1) into the opening on the electrical component mounting panel, until an audible click is heard, indicating the Rim (1) is secured to the electrical component mounting panel.
  3. Connect the electrical connections to the RIM (1).
    4. Fig 2: View Of Rear Integration Module Mounting Bracket & Fasteners
    GM625727Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical component mounting panel (1) to the vehicle body.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the electrical component mounting panel nuts (2).

    Tighten:  Tighten the nuts (2) to 9 N.m (80 lb in).

  6. Install the rear storage compartment trim. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
  7. Restore the drivers personalization settings. Refer to Driver Personalization in Personalization.
· About lemon-mirror