lemon-mirror:
Home >> Cadillac >> 2004 >> XLR >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Computer/Integrating Systems >> Repair Instructions >> Body Control Module (BCM) Programming/RPO Configuration >> BPP Sensor Calibration

BPP Sensor Calibration

IMPORTANT:
  • Always perform this procedure after the BCM was reprogrammed or after the brake pedal position sensor was replaced.
  • Do not press the brake pedal during the programming procedure.
  • A DTC C0278 00 and a DTC P0703 may be set by BCM and ECM before performing this procedure. The DTCs will clear after the procedure is performed.

Follow the instructions on the scan tool under Vehicle Control Systems>Module Replacement/Setup Procedures>BCM>BPP Sensor Calibration to perform this procedure.

· About lemon-mirror