lemon-mirror:
Home >> Cadillac >> 2004 >> XLR >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry System >> Repair Instructions >> Remote Control Door Lock Receiver Replacement >> Installation Procedure

Installation Procedure

  1. Connect the receiver connector and route the wire harness through the I/P carrier.
  2. Line up the receiver with the hole on the retainer.
    Fig 1: View Of Remote Control Door Lock Receiver & Screws
    GM1231031Courtesy of GENERAL MOTORS CORP.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the retaining screws to the remote control door lock receiver.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
  5. Perform the RCDLR Setup as follows:
    1. Connect a Tech?2 to the vehicle.
    2. Select RCDLR under Module Setup in the Vehicle Control Systems menu.
    3. Select Setup New RCDLR.
    4. Follow the on-screen instructions.
  6. Perform either the Programming Theft Deterrent System Components - Domestic or the Programming Theft Deterrent System Components - Export procedure, depending on actual vehicle equipment. Refer to Programming Theft Deterrent System Components (RCDLR Setup) or Programming Theft Deterrent System Components (Domestic Vehicles) or Programming Theft Deterrent System Components (Export Vehicles (including Canada)) .
  7. Perform the Tire Pressure Monitoring Sensor Learn. Refer to Tire Pressure Sensor Learn .
· About lemon-mirror