lemon-mirror:
Home >> Cadillac >> 2004 >> XLR >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Removal Procedure

Removal Procedure

  1. Turn the ignition switch to the OFF position.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  3. Disconnect the brake fluid pressure sensor connector.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Remove the two bracket bolts.
    6. Fig 1: View Of EBCM Connector, Bracket & Bolts
    GM1274761Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the electronic brake control module (EBCM) connector.
    7. Fig 2: View Of EBCM, BPMV & Bolts
    GM143452Courtesy of GENERAL MOTORS CORP.
  7. Remove the four EBCM to brake pressure modulator valve (BPMV) bolts.
  8. Separate the EBCM from the BPMV by gently pulling apart until separated.
· About lemon-mirror