lemon-mirror:
Home >> Cadillac >> 2005 >> DeVille DHS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Ignition Control Module Replacement - Bank 2 >> Installation Procedure

Installation Procedure

    Fig 1: Ignition Control Module
    GM602331Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Be sure the ignition cassette grounding spring and insulator are in place when installing the ignition cassette.
  1. Install the ignition control module.

    Install the ignition control module retaining screws.

    Tighten:  Tighten the ignition control module retaining screws to 0.8 N.m (7 lb. in.).

    Connect the spark plug boots to the spark plugs.

  2. Install the ignition cassette. Refer to Ignition Coil(s) Replacement - Bank 2 .
· About lemon-mirror