lemon-mirror:
Home >> Cadillac >> 2016 >> SRX Base >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> Rear Seat Heater Control Module Programming and Setup >> Rear Seat Heating Control Module Programming

Rear Seat Heating Control Module Programming

To program and setup an existing or new replacement rear seat heating control module, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) 
  2. On the SPS Supported Controllers screen, select Rear Seat Heating Control Module - Programming and follow the on-screen instructions.

If the rear seat heating control module fails to accept the program, verify all scan tool and rear seat heating control module connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTC's from all modules.
· About lemon-mirror