Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Electronic Brake Control Module (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Electronic Brake Control Module Bolt (1) - Install and tighten [4x] 3 N.m (27 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Primary Brake Pipe Fitting (1) - Install - Brake Pressure Modulator Valve Pipe Replacement (LGW, LGX)Brake Pressure Modulator Valve Pipe Replacement (LSY, LTA)
Connect the EBCM electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Chassis Front Wiring Harness (2) - Install
Chassis Front Wiring Harness Clip Nut (1) - Install and tighten 9N.m (80 lb in)
Engine Wiring Harness Fuse Block Bracket - Install - Engine Wiring Harness Fuse Block Bracket Replacement (LGW, LGX, LSY)Engine Wiring Harness Fuse Block Bracket Replacement (LTA-Driver Side)Engine Wiring Harness Fuse Block Bracket Replacement (LTA-Passenger Side)
Bleed the brake system. Antilock Brake System Automated Bleed
Program the EBCM. Control Module References
Center the steering angle sensor. Steering Wheel Angle Sensor Centering (without UKL) Steering Wheel Angle Sensor Centering (with UKL)