Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Catalytic Converter @ Exhaust Manifold Seal |
| Exhaust Manifold Gasket |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Exhaust Manifold Bolt (L8T) Refer to procedure for tightening sequence and torque values. |
Exhaust Manifold Replacement - Left Side , or Exhaust Manifold Replacement - Right Side |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Air Conditioning Evaporator Hose Bracket Bolt (L86) | 22N.m (16 lb ft) |
| Catalytic Converter Fastener | 50N.m (37 lb ft) |
| Exhaust Clamp | 30N.m (22 lb ft) |
| Exhaust Manifold Fastener (L83, L86) | |
|
23N.m (17 lb ft) |
|
27N.m (20 lb ft) |
| Exhaust Manifold Heat Shield Fastener-- Left Side (L83, L86) | 10N.m (89 lb in) |
| Exhaust Manifold Heat Shield Fastener-- Right Side (L83, L86) | 10N.m (89 lb in) |
| Exhaust Manifold Stud | 10N.m (89 lb in) |
| Exhaust Muffler Clamp Fastener | 30N.m (22 lb ft) |
| Front Body Exhaust Heat Shield Fastener | 9N.m (80 lb in) |
| Heat Shield Nut | 9N.m (80 lb in) |
| Heater Inlet and Outlet Hose Bracket Bolt | 9N.m (80 lb in) |
| U-Joint Yoke Retainer Bolt | 25N.m (18 lb ft) |