lemon-mirror:
Home >> Chevrolet >> 1992 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Testing >> Test 3

Test 3

  1. Disconnect RH window switch connector C1. See WIRING DIAGRAMS  . Turn ignition ON, and connect a test light between switch connector terminal "A" (Dark Blue/White wire) and ground. Test light should illuminate. Then connect a test light between switch connector terminal "B" (Tan wire) and ground. See WIRING DIAGRAMS  . Test light should illuminate. If test light illuminates in both cases, go to next step. If test light does not illuminate in both cases, check for open in dark blue/white or tan wires between LH and RH window switches.
  2. Connect test light between RH window switch connector terminals "A" and "B". See WIRING DIAGRAMS  . Test light should illuminate when LH switch is moved to UP position or DOWN position. If test light illuminates as specified, go to next step. If test light does not illuminate as specified, replace LH power window switch.
  3. Reconnect RH power window switch connector. Disconnect RH window motor connector. Connect test light between motor connector terminals "A" (Tan wire) and ground. Test light should illuminate. Connect test light between motor connector terminal "B" (Dark Blue/White wire) and ground. Test light should illuminate. See WIRING DIAGRAMS  . If test light illuminates as specified, go to next step. If test light does not illuminate as specified, check for open in dark blue/ white or tan wires between RH window switch and RH window motor. If wires are okay, replace RH window switch.
  4. Connect test light between RH window motor connector terminals "A" and "B". See WIRING DIAGRAMS  . Test light should illuminate when RH window switch is moved to UP position or DOWN position. If test light illuminates as specified, replace RH window motor. If test light does not illuminate as specified, go to next step.
  5. Connect test light between RH window switch connector C@ terminals "B" (Black wire) and "C" (Gray wire). See WIRING DIAGRAMS  . If test light illuminates, replace RH window switch. If test light does not illuminate, repair open ground circuit between RH window switch connector C2 terminal "C" (Black wire) and left kick panel. See WIRING DIAGRAMS  .
· About lemon-mirror