Programming Transmitters

Entering a specific button sequence on Driver Information Center (DIC) initiates Remote Function Actuation (RFA) programming. Pressing transmitter LOCK and UNLOCK button programs up to 3 transmitters. The Instrument Panel Cluster (IPC) indicates when programming sequence is complete. Remote control door lock receiver memory retains current access codes if a programming sequence is interrupted or battery is disconnected. Perform the following steps:

1) Turn ignition on. Turn radio off. Press Driver Information Center (DIC) RESET button to clear any Instrument Panel Cluster (IPC) warning messages. Press OPTIONS button on DIC until IPC display is blank.

2) Press and hold RESET button for 3 seconds. Press OPTIONS button until FOB TRAINING message is displayed. Press RESET button to begin programming sequence.

3) Simultaneously press and hold LOCK and UNLOCK buttons on first transmitter for 12 seconds. The IPC will indicate when that transmitter is programmed and when to proceed. Repeat this step for each transmitter.