Pass-Key(R) III System Quick Learn Procedure
NOTE:
PASS-Key(R) III system quick learn procedure is used to learn additional ignition keys. A learned key must be used to initiate procedure. Up to 10 ignition keys can be learned.
- Insert a valid ignition key into ignition switch. Turn ignition on. After a 2-second bulb test, turn ignition off and remove key.
- Within 10 seconds, insert new valid mechanical code unlearned key and turn ignition switch to RUN position. SECURITY indicator light will illuminate until key is learned. This may happen so quickly light illumination is not observed. Turn ignition off. Remove ignition key 10 seconds after light turns off.
- To learn additional keys, repeat step 2 . To exit procedure, turn ignition off for more than 10 seconds.