lemon-mirror:
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Starter
    GM211621Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to BATTERY DISCONNECT CAUTION in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the starter. Refer to STARTER MOTOR REPLACEMENT in Engine Electrical.
    4. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
    5. Fig 3: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  5. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
  6. Remove the CKP sensor retaining fastener.
  7. Remove the CKP sensor.
· About lemon-mirror