lemon-mirror:
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install electrical connections to PCM.

    Tighten:  Tighten bolts to 10 N.m (89 lb in).

  2. Install the PCM to the bracket.
  3. Position PCM water boot back into place.
  4. Close the hood.
  5. Connect negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  6. If the PCM was replaced, the replacement PCM must be programmed. Refer to Service Programming System (SPS) (Remote Procedure) or Service Programming System (SPS) (Pass-Thru Procedure) or Service Programming System (SPS) (Off Board Remote Procedure) or Service Programming System (SPS) (Off Board Pass-Thru Procedure) in Programming.
· About lemon-mirror