lemon-mirror:
Home >> Chevrolet >> 2004 >> Monte Carlo LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.4L (Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the power steering pump and reposition. Refer to Power Steering Pump Replacement (3.4L) or Power Steering Pump Replacement (3.8L) in Power Steering System.
  2. Disconnect the camshaft position (CMP) sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
  5. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
    6. Fig 1: Removing CMP Sensor
    GM16120Courtesy of GENERAL MOTORS CORP.
· About lemon-mirror