lemon-mirror:
Home >> Chevrolet >> 2005 >> Equinox LS, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.4L - Introduction >> Repair Instructions >> Fuel Tank Module Replacement - Primary >> Installation Procedure

Installation Procedure

    Fig 1: View Of Fuel Tank Module
    GM1226439Courtesy of GENERAL MOTORS CORP.
  1. If the fuel level sending unit is being replaced, install the fuel level sending unit onto the new fuel pump. Refer to Fuel Level Sensor Replacement - Primary .
  2. Insert the new primary fuel pump module assembly with the level sender and the new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.
  3. Use the J 45722  to install the fuel pump lock ring. See Special Tools .
  4. Connect the wiring harness to the primary fuel pump module and fuel tank pressure sensor.
  5. Install the secondary fuel pump module. Refer to Fuel Tank Module Replacement - Secondary .
  6. Install the fuel tank. Refer to Fuel Tank Replacement (FWD)  or Fuel Tank Replacement (AWD) .
· About lemon-mirror