lemon-mirror:
Home >> Chevrolet >> 2008 >> Aveo Base >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Immobilizer System >> Repair Instructions >> Theft Deterrent Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Immobilizer Control Unit & Electrical Connector
    GM1252101Courtesy of GENERAL MOTORS CORP.
  1. Install the immobilizer control unit.
  2. Connect the electrical connector to the immobilizer control unit.
    3. Fig 2: View of Instrumental Panel Lower Cover
    GM1248378Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: After replacing the immobilizer, the keys must be re-authorized using the key coding procedure. Refer to Programming Theft Deterrent System Components (Tech 2) or Programming Theft Deterrent System Components (Scan 100) .
  3. Install the upper and the lower steering column cover panels.
    4. NOTE: Refer to Fastener Notice .
  4. Install the lower steering column cover panel screws.

    Tighten:  Tighten the lower steering column cover panel screws to 3 N.m (27 lb in).

  5. Turn the steering wheel in order to access the upper steering column panel screw holes. Install the upper steering column cover panel screws.

    Tighten:  Tighten the upper steering column cover panel screws to 3 N.m (27 lb in).

  6. Connect the negative battery.
· About lemon-mirror