lemon-mirror:
Home >> Chevrolet >> 2011 >> Cruze LS, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Object Alarm Module Programming and Setup >> Parking Assist Control Module Programming

Parking Assist Control Module Programming

To program and setup an existing or new replacement parking assist control module, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select Object Alarm Module - Configuration and follow the on-screen instructions.

If the Object Alarm Module fails to accept the program, verify all scan tool and parking assist control module connections are secure.

NOTE: After programming is completed, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTC's from all modules.
· About lemon-mirror