Installation Procedure

Fig 1: Installing BCM Into Bracket

Courtesy of GENERAL MOTORS CORP.

Install the BCM (1) into the bracket.
Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

Fig 2: Body Control Module & Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connectors (2) to the BCM (1).

Fig 3: Identifying Right Side Knee Bolster Trim Panel
Courtesy of GENERAL MOTORS CORP.
Install the right side knee bolster trim panel. Refer to Passenger Knee Bolster Replacement .
If you replaced the BCM, program the module. Refer to Body Control Module Programming and Setup .
Refer to Control Module References for programming and setup information.