Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Remove the 11 lower fasteners securing the front wheelhouse liner front liner to the frame. Refer to Front Wheelhouse Front Liner Replacement .
- Pull the front wheelhouse liner away from the frame to access the wheel speed sensor electrical connector.
- Disconnect the wheel speed sensor electrical connector (1) and release the connector from the frame.
- Release the harness clip (2) from the frame.
- Release the harness clips (3) from the lower control arm.
- Clean the wheel speed sensor mounting area on the steering knuckle of any accumulated dirt and debris.
- Remove the wheel speed sensor bolt (1).
- Remove the wheel speed sensor (1) from the steering knuckle.
- Release the harness clip (2) from the steering knuckle and remove the wheel speed sensor.
WARNING:
Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.
WARNING:
Refer to Brake Dust Warning .