Installation Procedure

Insert the electronic parking brake control module (1) hanger into the grommet in the vehicle body.

Fig 1: Electronic Parking Brake Control Module
Courtesy of GENERAL MOTORS COMPANY
Raise the front of the electronic parking brake control module and install onto the studs in the vehicle body.
Install the electronic parking brake control module nuts (1) and tighten to 10 N.m (89 lb in).

Fig 2: Electronic Parking Brake Control Module And Nuts
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Connect the electronic parking brake control module electrical connector.
Install the parking brake cable nut (1) to the electronic parking brake control module and tighten to 6 N.m (53 lb in).

Fig 3: Parking Brake Cable And Nut
Courtesy of GENERAL MOTORS COMPANY
Install the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
Install the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling .
Program the electronic parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup