Brake Control Brake Pedal Position Sensor Calibration

The brake controls brake pedal position sensor does not require calibration often. Calibration brake controls brake pedal position sensor might be required after certain service procedures are performed. Some of these procedures are as follows:

• Electronic brake control module (EBCM) replacement.
• Brake Control Brake Pedal Position Sensor replacement

The Brake Controls Brake Pedal Position Sensor Calibration procedure can be completed with a scan tool using the following steps:

1. Place the vehicle in Service Mode.
2. Place the transmission in PARK or neutral.
3. Do not apply the brake pedal.
4. Install the scan tool to the data link connector.
5. Select Brake Controls Offset Learn in the EBCM Configuration/Reset Functions list.
6. Follow the scan tool directions to complete the calibration procedure.
7. Clear any DTCs that may be set.