lemon-mirror:
Home >> Chevrolet >> 2015 >> Suburban LS, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Removal Procedure

Removal Procedure

CAUTION:

To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

  1. Place the ignition switch in the OFF position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: EBCM Bolts
    GM3255759Courtesy of GENERAL MOTORS COMPANY
  3. Thoroughly clean the area around the electronic brake control module (EBCM) of all dirt and debris.
  4. Disconnect the EBCM electrical connector.
  5. Remove the EBCM bolts (1).
    6. Fig 2: EBCM And Brake Pressure Modulator Valve (BPMV)
    GM3255766Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not attempt to pry or lever against the EBCM.

  6. Carefully separate the EBCM (1) from the brake pressure modulator valve (BPMV) by pulling straight away from the BPMV.
· About lemon-mirror