Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Ignition and Start Switch Housing Bolt | Tighten Until Bolt Head Shears |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Conductive M6 Nut | 8 N.m (71 lb in) |
| Conductive M7 Bolt | 9 N.m (80 lb in) |
| Conductive M8 Nut | 22 N.m (16 lb ft) |
| Conductive M10 Nut | 45 N.m (33 lb ft) |
| Engine Wiring Harness Junction Block Cable Nut | 10 N.m (89 lb in) |
| Front Compartment Fuse Block Cover Nut | 6 N.m (53 lb in) |
| Fuse Block Wiring Harness Terminal Nut | 4.7 N.m (42 lb in) |
| Ignition and Start Switch Bolt | 2 N.m (18 lb in) |
| Positive Battery Cable Nut | 4.7 N.m (42 lb in) |
| Starter and Generator Cable Nut | 10 N.m (89 lb in) |