lemon-mirror:
Home >> Chevrolet >> 2018 >> Colorado Base >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Repair Instructions >> Parking Brake Control Module Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. GM3745657

    While holding the parking brake intermediate cable stationary, loosen the parking brake intermediate cable adjustment nut (1).

  3. GM3745665

    Disconnect the parking brake control module cable (1) from the parking brake intermediate cable connector (2).

  4. GM3745669

    Compress the parking brake control module cable locking tabs (1) and remove the cable from the forward body mount.

  5. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  6. GM3745674

    Release the parking brake control module cable grommet (1) from the front floor panel.

  7. Lower the vehicle.
  8. Remove the body control module bracket. Refer to Body Control Module Bracket Replacement .
  9. Remove the left body hinge pillar garnish molding. Refer to Body Hinge Pillar Garnish Molding Replacement (Left Side) .
  10. Position aside the front floor carpet to expose the parking brake control module cable.
  11. Disconnect the parking brake indicator switch electrical connector.
  12. GM3745677

    Remove the parking brake control module nuts (1).

  13. Remove the parking brake control module and cable assembly from the vehicle.
· About lemon-mirror