Installation Procedure

Brake Pressure Modulator Valve Bracket - Install - Brake Pressure Modulator Valve Bracket Replacement
Courtesy of GENERAL MOTORS COMPANY

Carefully install the brake pressure modulator valve (3) and the brake pressure modulator valve bracket (2) to the vehicle.

CAUTION:

Refer to Fastener Caution .

Brake Pressure Modulator Valve Bracket Bolt (1) - Install and tighten 22 N.m (16 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1)@Electronic Brake Control Module (2) - Connect
Courtesy of GENERAL MOTORS COMPANY

WARNING:
Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel lockup will occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by doing an Antilock stop.

Brake Pressure Modulator Valve Primary Pipe (1)@Brake Pressure Modulator Valve (2) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Make sure, that the electronic brake control module is fully seated into the grommets after the brake pipes are tightened.

Brake Pressure Modulator Valve Primary Pipe (1)@Brake Pressure Modulator Valve (2) - Install and tighten32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Make sure, that the electronic brake control module is fully seated into the grommets after the brake pipes are tightened.

Brake Pipe Fitting (1)@Brake Pressure Modulator Valve (3) - Install and tighten [4x] 18 N.m (13 lb ft)
Brake Pipe Fitting (2)@Brake Pressure Modulator Valve (3) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Radiator Surge Tank (1) - Install
Radiator Surge Tank Bracket Clip (2) - Install
Dash Upper Extension Panel Opening Cover - Install - Dash Upper Extension Panel Opening Cover Replacement
Enable the high voltage system. High Voltage Enabling
Program the electronic brake control module. Control Module References
Bleed the brake system. Hydraulic Brake System Bleeding