Removal Procedure

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Place the ignition switch in the OFF position.
Raise and support the vehicle. Lifting and Jacking the Vehicle
Disconnect the electronic brake control module (EBCM) electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Electronic Brake Control Module Bolt (1) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do NOT pry the components apart.

Electronic Brake Control Module (1) - Remove