lemon-mirror:
Home >> Chevrolet >> 2020 >> Corvette 2D Convertible >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K218 Front Suspension Lifting/Lowering Hydraulic Power Pack Module: Programming and Setup >> Reprogram Control Module

Reprogram Control Module

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. Select Key Provisioning Button (Serial Data Authentication Configuration button) in SPS.
  3. Perform Key Provisioning.
  4. After Key Provisioning is complete, wait 10 minutes to allow the vehicle/modules to go to sleep.
  5. On the SPS Supported Controllers screen, select K218 Front Suspension Leveling/Lifting Hydraulic Power Pack Module - Programming and follow the on-screen instructions.
  6. Clear DTCs.
  7. With a scan tool, perform the suspension system calibration procedure, if applicable.
· About lemon-mirror