lemon-mirror:
Home >> Chevrolet >> 2022 >> Silverado 1500 ZR2 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K194 Rear Gate Module: Programming and Setup >> Replace and Program Control Module

Replace and Program Control Module

NOTE:

The endgate must be completely closed and latched, if the endgate is open or ajar during programming, the power endgate system may become inoperative without any DTCs indicated

To program a replacement control module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. On the SPS Supported Controllers screen, select K194 Rear Gate Module - Programming and follow the on-screen instructions.
  3. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
· About lemon-mirror