lemon-mirror:
Home >> Chevrolet >> 2023 >> Silverado 1500 ZR2 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K194 Rear Gate Module: Programming and Setup >> Reprogram Control Module

Reprogram Control Module

NOTE:

The endgate must be completely closed and latched, if the endgate is open or ajar during programming, the power endgate system may become inoperative without any DTCs indicated

To reprogram an existing control module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. On the SPS Supported Controllers screen, select K194 Rear Gate Module - Programming and follow the on-screen instructions.
  3. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
· About lemon-mirror