lemon-mirror:
Home >> Chevrolet >> 2024 >> Traverse LS, FWD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> B218L Side Obstacle Detection Control Module - Left: Programming and Setup >> Replace and Program ECU or Reprogram ECU

Replace and Program ECU or Reprogram ECU

To program a replacement or an existing ECU, perform the following procedure:

NOTE:
  • Due to continuous improvements, the on screen selections may vary from instructions below.
  • Some systems only have one programmable Side Object Sensor Module.
  1. Ignition / Vehicle OFF
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select B218 Side Object Sensor Module then select B218R Right Side Object Sensor Module or B218L Left Side Object Detection.
  4. On the SPS Select Function / Sequence screen, select Sequential Programming or Programming
  5. Clear DTCs.
· About lemon-mirror