Ignition System - V8: Overhaul: Disassembly

Remove distributor cap. Using 2 screwdrivers, pry off rotor from shaft. Remove reluctor by prying up from bottom of reluctor using 2 pry bars or screwdrivers with a maximum width of 7/16". Be careful not to distort or damage reluctor teeth.
Remove 2 screws and lock washers attaching plate to housing, and lift out plate and pick-up coil(s) as an assembly. DO NOT attempt to remove distributor cap clamps, as they are peened in place.
If distributor has more than .006" (.15 mm) shaft side play, replace housing shaft and reluctor sleeve by removing shaft retaining pin and sliding retainer off end of shaft.