lemon-mirror:
Home >> Chrysler >> 1990 >> Imperial >> Repair and Diagnosis >> Body & Frame >> Mirrors - Power >> Testing >> Mirror Motor Test

Mirror Motor Test

  1. Remove power mirror switch from mounting position. Disconnect wiring harness at switch connector.
  2. Disconnect switch wiring harness at connector. In the case of memory mirrors (Green 8-pin mirror connector and memory switch in driver's door panel), the switch wiring disconnects from the cowl top harness rather than the mirror harness.
  3. Using 2 jumper wires, one connected to a 12-volt source and the other to a good vehicle ground, refer to the appropriate MIRROR MOTOR TEST CHARTS  for wire hook-ups at the wiring harness (harness side, not switch side). If 2 wire codes are indicated in the "12 volts" column, both wires must be hooked up to 12 volts simultaneously for test to work. 4) If results shown in chart are NOT obtained, check circuit for broken or shorted wire. If wiring is okay, replace mirror assembly as required.
· About lemon-mirror