Power Mirror Motor
Disconnect power mirror switch connector. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Connect one end of a jumper wire to a 12-volt source and other end to specified power mirror switch connector terminals. Connect one end of another jumper wire to a good ground and other end to specified power mirror switch connector terminals. See POWER MIRROR MOTOR TEST table. If mirror does not operate as specified, check for open or shorted circuit or replace power mirror assembly. See Fig 1.
POWER MIRROR MOTOR TEST
| Apply 12 Volts To Terminal No. |
Ground Terminal No. |
Mirror Operation (Right) |
Mirror Operation (Left) |
| Switch Connector |
| 12 |
6 |
Up |
|
| 13 |
1 |
|
Up |
| 6 |
12 |
Down |
|
| 1 |
13 |
|
Down |
| 6 |
7 |
Right |
|
| 1 |
8 |
|
Right |
| 7 |
6 |
Left |
|
| 8 |
1 |
|
Left |
| Door Connector |
| 6 |
2 |
Up |
Up |
| 2 |
6 |
Down |
Down |
| 2 |
5 |
Right |
Right |
| 5 |
2 |
Left |
Left |
| 1 |
3 |
|
|
Courtesy of CHRYSLER CORP.