lemon-mirror:
Home >> Chrysler >> 2001 >> Sebring Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Instrument Cluster Systems >> Charging System Warning Indicator Not Operating Properly

Charging System Warning Indicator Not Operating Properly

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Perform self-test on instrument cluster. Press and hold TRIP/RESET button and turn ignition on. If charging system indicator does not turn on for 4 seconds then turn off, go to step  3 . If charging system indicator turns on for 4 seconds then turn off, go to next step.
  2. Connect scan tool to Data Link Connector (DLC) located under left side of instrument panel. See Figure . Turn ignition on. Using scan tool, check for DTCs. If any DTCs are present, diagnose and repair DTCs before continuing. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM. If no DTCs are present, go to next step.
  3. Remove and disconnect instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Remove and inspect charging system warning indicator bulb and socket. Replace bulb or socket as necessary. If bulb and socket are okay, diagnose PCI communication circuit. See BUS +/- SIGNALS OPEN OR NO RESPONSE FROM INSTRUMENT CLUSTER  under COMMUNICATIONS. If bus circuit is okay, replace instrument cluster.
· About lemon-mirror