Shift Quality Quick-Learn Procedure
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2003 Jeep Wrangler, 2003 Jeep Liberty, 2003 Jeep Grand Cherokee, 2003 Dodge Viper, and 2003 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
The quick learn procedure requires the use of the DRBIII® scan tool.
This program allows the electronic transmission system to recalibrate itself. This will provide the proper transmission operation. The quick learn procedure should be performed if any of the following procedures are performed:
- Transmission assembly replacement.
- Transmission control module replacement.
- Solenoid Pack Replacement.
- Clutch plate and/or seal replacement.
- Valve body replacement or recondition.
To perform the quick learn procedure, the following conditions must be met:
- The brakes must be applied.
- The engine speed must be above 500 RPM.
- The throttle angle (TPS) must be less than 3 degrees.
- The shift lever position must stay in Park until prompted to shift to overdrive.
- The shift lever position must stay in overdrive after the SHIFT TO OVERDRIVE prompt until the DRBIII® indicates the procedure is completed.
- The calculated oil temperature must be 60-200°F (16-93°C).