Steering Column Control Module: Assembly

Fig 1: MULTIFUNC FROM CIRCUIT BOARD

Courtesy of DAIMLERCHRYSLER CORP.

1. Position the Steering Column Control Module (SCCM) circuit board onto the multi-function switch.
   Fig 2: MULTIFUNC REAR

   Courtesy of DAIMLERCHRYSLER CORP.
2. Install the multi-function switch and circuit board and tighten the three screws (1) from the bottom of the SCCM.
   Fig 3: SCCM STALKS

   Courtesy of DAIMLERCHRYSLER CORP.
3. Install the steering column telescoping lever (3).
   Fig 4: SPEED CONTROL FROM SCCM

   Courtesy of DAIMLERCHRYSLER CORP.
4. Install the speed control switch (1).
   Fig 5: STRUT UNDEDER ESP

   Courtesy of DAIMLERCHRYSLER CORP.
5. If equipped with manual telescoping column  Install the strut (1).
   Fig 6: SCCM STALKS

   Courtesy of DAIMLERCHRYSLER CORP.
6. If equipped with electronic telescoping column  , install the electric tilt lever and switch (3).
   Fig 7: STEERING ANGLE SENSOR SCREW

   Courtesy of DAIMLERCHRYSLER CORP.
7. If equipped wit ESP  Install the steering angle sensor and screw (3) located at the six o'clock position.
   Fig 8: CLOCKSPRING SCREWS

   Courtesy of DAIMLERCHRYSLER CORP.
8. Install the clockspring and screws (1).
9. If equipped with ESP  Recalibrate the steering angle sensor using the scan tool.