Module-Steering Column Control: Assembly

Fig 1: Multi-Function From Circuit Board

Courtesy of DAIMLERCHRYSLER CORP.

1. Position the Steering Control Module (SCM) onto the multi-function switch.
   Fig 2: Multi-Function Switch Rear

   Courtesy of DAIMLERCHRYSLER CORP.
2. Install the multi-function switch and SCM in the SCCM Shroud and tighten the three screws (1) from the bottom.
   Fig 3: Identifying SCCM Components

   Courtesy of DAIMLERCHRYSLER CORP.
3. Install the steering column telescoping lever (3).
   Fig 4: Speed Control from SCCM

   Courtesy of DAIMLERCHRYSLER CORP.
4. Install the speed control switch (1).
   Fig 5: Installing Strut

   Courtesy of DAIMLERCHRYSLER CORP.
5. If equipped with manual telescoping column  , install the strut (1).
   Fig 6: Identifying SCCM Components

   Courtesy of DAIMLERCHRYSLER CORP.
6. If equipped with electronic telescoping column  , install the electric tilt lever and switch (3).
   Fig 7: Steering Angle Sensor Screw

   Courtesy of DAIMLERCHRYSLER CORP.
7. If equipped with ESP  , install the steering angle sensor and screw (3) located at the six o'clock position.
   Fig 8: Clockspring Screws

   Courtesy of DAIMLERCHRYSLER CORP.
8. Install the clockspring and screws (1) leaving one out so it will not unwind.
9. Install the SCCM on the steering column, (Refer to STEERING/COLUMN/STEERING COLUMN CONTROL MODULE - INSTALLATION)  and tighten the one clockspring screw (1) that was left loose.