lemon-mirror:
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Power Door Locks >> Remote Keyless Entry Module >> Installation

Remote Keyless Entry Module: Installation

  1. Snap the remote keyless entry module onto the BCM.
  2. Connect BCM to the Junction Block.
  3. Connect the BCM and junction block together.
  4. Install the Junction Block/BCM into vehicle.
  5. Connect BCM wire connectors and install the assembly onto instrument panel.
  6. Install the Junction Block/BCM by pushing straight up.
  7. Install the Junction Block three mounting screws.
  8. Install the wire harness connectors to the Junction Block.
  9. Install the silencer.
  10. Install the left lower instrument panel trim.
  11. Install the instrument panel inboard bezel. (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) .
  12. Install the instrument panel center bezel. (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - INSTALLATION) .
  13. Install the instrument panel outboard bezel. (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) .
  14. Install the left end cover.
  15. Connect the remote battery negative cable to the remote terminal on the shock tower.
· About lemon-mirror