Charging System: Charging: Generator: Removal: Generator-5.7L

Fig 1: Generator - 5.7L

Courtesy of CHRYSLER LLC

WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WIRE (B+ WIRE) FROM GENERATOR. FAILURE TO DO SO CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM.

1. Disconnect and isolate negative battery cable at battery.
2. Remove generator drive belt. Refer to REMOVAL .
3. Remove upper generator mounting bolt (1).
   Fig 2: TRANS COOLER LINE CLAMP

   Courtesy of CHRYSLER LLC
4. Raise and support vehicle.
5. Remove lower splash shield.
6. Remove bolt (1) from transmission cooler line clamp at right crossmember (3) and reposition transmission cooler line (2).
   Fig 3: Generator Support Bracket - 5.7L

   Courtesy of CHRYSLER LLC
7. Remove generator support bracket nut (4) and bolt (3). Remove support bracket (1).
8. Unsnap plastic insulator cap from B+ output terminal.
9. Remove B+ terminal mounting nut at rear of generator. Disconnect terminal from generator.
10. Disconnect field wire connector at rear of generator by pushing on connector tab.
    Fig 4: Generator - 5.7L

    Courtesy of CHRYSLER LLC
11. Remove lower generator mounting bolt (1).
12. Remove generator from vehicle.